American Dynamics RAS918LSP Especificações descarregar pdf (Página 14)

SPEEDDOME ULTRA VII EIS DAY/NIGHT CAMERA DOME 8200-0184-14, REV. A

INSTALLATION AND SERVICE GUIDE

14 of 37

6. Connect the 4-pin plug (alarm input/output) to

the 4-pin receptacle (

Figure 14).

a. Feed the cable through the access hole in

the base.

b. Connect alarm wires to the 4-pin plug (refer

to chart below).

c. Insert the plug into the mating receptacle in

the top of the housing and eyeball assembly.

Alarm connections

Pin Color Designation

1 — +12Vdc

2 — Alarm Out

3 — Alarm In

4 — Common

Figure 14. Cable connections (Manchester

requires separate cables for data

and power)

7. Connect the housing and eyeball assembly to

the base (

Figure 15) by aligning the Cap and

Base tabs and then turning clockwise until you

hear a click.

Figure 15. Connecting housing and eyeball

assembly to base (cables and

lanyard not shown)

8. Apply power and wait a few seconds for the

dome to begin its homing routine. The homing

routine indicates that address was placed into

dome memory and that dome is ready for

programming.

Note: If the homing routine does not occur or if

the dome does not respond to commands,

check the cable wiring by referring to the LED

response tables in Appendix A.

9-pin plug

LEDs CR2,

CR3, and CR4

visible through

opening.

4-pin plug

Note: Align tabs

on Cap and

Base.

Turn clockwise

to latch

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 36 37

Comentários a estes Manuais

Sem comentários

American Dynamics RAS918LSP Especificações Página 14

Comentários a estes Manuais

Manuais e produtos relacionados com Câmaras de segurança American Dynamics RAS918LSP